Leviton AESS5 User Manual download pdf (Page 6)

2. Pull the ball/shaft (3) out of the wall bracket (4).

3. Slide on the molded nut (2) onto the ball/shaft (3) with threaded

opening facing the ball, and thread on the metal nut (1) all the way

onto the ball/shaft (3), with the nut (1)ʼs “knurled” surface facing away

from the ball.

4. Screw on the ball/shaft (3) into the threaded insert on the back of the

speaker cabinet until it is fully seated against the bottom of the insert.

5. Tighten the “knurled” nut (1) using a crescent wrench until it is ﬁrmly

seated against the back of the speaker and has fully locked the

ball/shaft (3) and the speaker cabinet together. Please note that once

this nut is tightened, it may embed some marks on the back of the

speaker where the attachment is made. However, these marks will be

covered by the nut (1).

6. Mount the wall bracket (4) onto a wood stud on the wall, using #10,

minimum 1 inch long, wood screws (6, not included). If necessary,

use a stud ﬁnder to locate the studs behind the drywall. Make sure

that all 4 screws are driven into the stud and not in drywall. If the

bracket needs to be mounted on drywall, the use of properly selected

and installed wall-anchors and screws is essential.

7. Holding the speaker cabinet with both hands, reinsert the ball portion

of the ball/shaft (3) into the wall bracket (4).

8. Hand tighten the molded nut (2) while positioning the speaker for the

intended orientation.

9. Once the orientation of the speaker is ﬁnalized, use the metal bar (5)

in one of the holes on the molded nut (2) and tighten securely.

1 – Metal Nut (2)

2 – Molded Nut (2)

3 – Ball/Shaft (2)

4 – Wall Bracket (2)

5 – Metal bar (1)

6 – Wood Screw (not included)

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Leviton AESS5 User Manual Page 6